Difference between revisions of "MainPage:Nuclear:KaonDetector:PMTCharacteristics"

From cua_phy
Jump to navigation Jump to search
Line 42: Line 42:
 
|}
 
|}
  
To see the evaluation of the relative aerogel light yield, done in a similar way as we did the PMT analyzis, click here.
+
To see the evaluation of the relative aerogel light yield, done in a similar way as we did the PMT analyzis, click [[MainPage:Nuclear:KaonDetector:AerogelCharacteristics|here]].
  
 
== PMTs at CUA ==
 
== PMTs at CUA ==

Revision as of 17:00, 10 December 2012

This page is under construction.

⇐ Back to the Kaon Detector page

Control and data acquisition

  • Coda Logbook: Some details on the data acquisition are registered in the online logbook.
  • COSMOS_Files:Page with the codes used in COSMOS to scan the PMTs

Kaon Aerogel Detector prototype - PMTs comparison

In order to compare the different PMT options we may have to install in the Kaon Aerogel Detector, a set of cosmic rays data was acquired with the CUA's prototype. Details of the prototype can be found in the Prototype page.

All the other configuration of the prototype were kept the same, just the PMT was exchanged between one test and the other. The setup was configured as follows:

  • Cosmic ray configuration (two triggering PMTs with scintillator on the top and bottom of the prototype)
  • 08 aerogel tiles with 1.030 refractive index
  • Mylar covering the internal walls of the prototype
  • High voltage of -1.80 kV on the PMT
PMTs comparison under cosmic ray test - Aerogel Prototype
Blast PMT model XP4500/B s/n 09650. Calibration from run 481. 08 tiles of aerogel 1.030.
HMS PMT s/n 60158. Calibration from run 805. 08 tiles of aerogel 1.030.
Hamamatsu PMT model R1250 s/n RA1815. Calibration from run 1096. 08 tiles of aerogel 1.030.
Summary of the PMT evaluation - Aerogel Prototype
PMT evaluation using CUA Aerogel Detector prototype. 08 tiles of aerogel 1.030.

To see the evaluation of the relative aerogel light yield, done in a similar way as we did the PMT analyzis, click here.

PMTs at CUA

The group is performing different experiments with some PMT to construct a tool to analyse the equipment that will be used in the aerogel detector.

Since the Summer 2011, the Nuclear Physics group at CUA is performing tests on the following PMTs:

  • PMT model XP4500B S/N 09641 (with electronic base #101)
  • PMT model XP4500B S/N 09650 (with electronic base #102)
  • PMT model XP4500B S/N 01414 (with electronic base #100)
  • PMT model XP4500B S/N 09561 (with electronic base #102)

Previous analysis of PMT's gain

The University of South Carolina had analyzed the PMT before it comes to JLab. It was done in the summer of 2011. The plots with the main characteristics of each PMT, separated by its serial number, is shown in Gain Plots.

A table with these data can also be download as a spreadsheet: File:PMTcatalog.xls.

Position dependence of incident photon

Position dependence setup for PMT characterization
PositionDependence1.JPG
PositionDependence2.JPG
PositionDependence3.JPG

Details on the step motor that are being used in the position dependence experiment can be found in the following links: